Skip to content

Tekla Sync

Keep your nest in step with the Tekla model without starting again.

Save as, Open and Sync

The Parts and Results pages share the same Save as, Open and Sync buttons. Save a job to a file and open it later. A job can be saved before any nest result exists (a parts-only job) and nested when you are ready. Sync reads the Tekla model again and needs a Tekla connection.

The change preview

Sync does not change anything until you agree. It first shows what was added, removed, changed or renamed in the Tekla model, grouped by nesting group, and says which groups will re-nest. Apply the changes, or close the preview and nothing is touched.

Only affected groups re-nest

Groups that the change does not touch keep their layouts. Only the changed groups are nested again and merged into the result, so a small change in the model does not move every sheet or bar.

Draft and Cut

Each sheet or bar has a shop status, Draft or Cut. Set it with the status dropdown in the viewer header, from the group "..." menu or by right-click, and use the Mark job button for the whole job. Each group shows a count such as "3/4 cut". Files saved by an older version with the status Sent open as Cut.

Status Meaning
Draft The default. The layout can change when you re-nest.
Cut The layout is cut or sent to the shop. It is locked: Sync and Run nest keep it as it is.

Changed parts on Cut layouts

PLTNest decides this automatically, so there is no per-part question. If the changed part is smaller and fits inside the old cut part, with its old holes inside the new holes or in the offcut, it is reworked: it is made from the old piece and the leftover becomes scrap or a remnant. Otherwise the part is nested again on new stock or remnants and the old part is marked obsolete. Deleted parts and quantity decreases are marked obsolete. The Sync preview shows one row per part mark.

If you would rather not touch any Cut layout, choose Keep all Cut parts as they are. If you press Run nest on a job that has Cut layouts, PLTNest asks whether to keep them and re-nest the rest, or to discard the statuses and nest everything again.

Export and status

After an export PLTNest asks "Mark exported layouts as Cut?" so the layouts you just exported are locked. When a job has both Draft and Cut layouts, Export ALL shows a Status filter: Draft, Cut or Both.

Changes log

The Changes log is a full record of every change to Cut layouts across Syncs: reworked, re-nested and obsolete parts. Use the filter and search to find a part, and export the log as a CSV file for the shop.

Update export

Instead of exporting everything again, choose "Update a previous export" and pick the earlier export folder. Only the files of changed groups are replaced, Cut layouts are left untouched, and a change report CSV is written in that folder. If a Cut layout changed, its new content is written under a new name and the old file is not touched. A folder exported by an older version has no update manifest, so a full export is written to a new folder instead.

The "Tekla model changed" banner

When the Tekla model is saved or renumbered after your last sync, PLTNest shows a banner with the number of groups that are out of date. Press Sync in the banner to review the changes.